Hey guys! Today I have the February Fandom Flakies Box to share with you. This box consist of three polishes. The polishes are made by Bee's Knees Lacquer, Night Owl Lacquer and a guest maker each month. The guest maker this month is Jior Couture and their fandom theme is Bob's Burgers. Read on for more info!
*All photos are taken indoors under 30W Daylight Bulbs.
*I angle my hand in direct lighting as well as low lighting to capture as many of the shifts as I am able.
*All photos shown with a fast dry top coat unless otherwise stated.
Bee’s Knees Lacquer-Girl Power
Bee’s Knees Lacquer-Girl Power
Described as a guacamole green with rich blue/red UCC flakes and gold/green/purple holo flakes. Shown here in 3 coats, plus top coat. Formula was good and applied well. If you have no or minimal free edge you could probably get away with just 2 coats. Dries with some texture so a top coat is needed for a full, glossy finish.
Night Owl Lacquer-It Takes Guts To Be Yourself
Described as a wine toned base filled with red/copper/gold and purple/burgundy/bronze multichrome flakes. Shown here in 2 coats, plus top coat. Formula was good and applied well. Dries with some texture so a top coat is needed for a full, glossy finish.
Described as a wine toned base filled with red/copper/gold and purple/burgundy/bronze multichrome flakes. Shown here in 2 coats, plus top coat. Formula was good and applied well. Dries with some texture so a top coat is needed for a full, glossy finish.
Jior Couture-Rupa
Described as a berry pink(cool) to light pink(warm) thermal with copper/bronze microglitter and pink/gold/copper multichrome flakes. Shown here in 3 coats, plus top coat. Formula was sheer but builds up well. Dries with some texture so a top coat is needed for a full, glossy finish. Transitioned easily.
Described as a berry pink(cool) to light pink(warm) thermal with copper/bronze microglitter and pink/gold/copper multichrome flakes. Shown here in 3 coats, plus top coat. Formula was sheer but builds up well. Dries with some texture so a top coat is needed for a full, glossy finish. Transitioned easily.
Ribbits and Stickits-Waterslide Decals
Instructions:
1. Paint nails, let dry completely.
2. Cut out the desired image.(Try cutting as close as possible to the image)
3. Place in warm water for 5-10 seconds.
4. Using your thumb & index finger slide the paper backing from the image.
5. Lightly dampen the back of the decal.
6. Place image on your nail, pressing down to remove any air bubbles.
7. Seal it with a top coat.
Tip:
If you prefer to use the decal over a colored/darker polish it's best to paint the back of the image with white polish/acrylic paint letting it dry before applying it to the nail.
Ribbits and Stickits-Acetone Additive
A scented glycerin and oil mixer that you mix with your acetone to prevent drying from pure acetone.
Using this makes it so your nails and cuticles aren't left with that yukky white residue, dry nails and dry cuticles. This is an 18ml bottle in the scent of "Blueberry Girl" which is described as blueberries, strawberries, raspberries, blackberries, boysenberries, cheesecake, cinnamon, cream, crust andvanilla. I added half the bottle to my 8oz container of acetone to achieve the results below when using it.
Ingredients: Glycerin, Distilled Water, Fragrance Oil, Polysorbate 80, and Jojoba Oil
Please note: There will also be another scent available!
Pumpkin Cinn-uhhh, Butts - A pumpkin pie filling, milk, yellow cake, butter, pecans, cinnamon, honey, coconut, maple vanilla sandalwood, chocolate, coffee, caramel, French vanilla, vanilla bean and nutmeg.Please note: There will also be another scent available!
Ribbits and Stickits-Vinyl Stickers
Instructions:
1. Scrape over the entire image going over it several times(use a credit card or something with a thin hard edge) This will help the vinyl stick to the transfer sheet.
2. Place the decal face down & slowly peel the white backing from the translucent transfer sheet.
3. Slowly remove transfer sheet, making sure all of the pieces of the vinyl are sticking to the transfer tape.
4. Clean the surface where you are applying your sticker.
5. Add your sticker to the surface, smooth down.
6. Take your scraper & scrape all over the image(use your fingers if scraping isn't an option)
7. Slowly & carefully remove the transfer sheet leaving your sticker decal in place.
Please note: There will be 6 different stickers to chose from a Tina, a Louise, a Bob, a Linda, a Gene and a Kuchi Kopi.
Available February 12th at noon EDT
and ends 11/19th at 11:59pm EDT
and ends 11/19th at 11:59pm EDT
CONVERSATION